Assembling The Vacuum Cleaner; Operation; Transport And Storage - Koenic Kvc 710 Gebrauchsanleitung

English

Assembling the vacuum cleaner

Insert the suction hose into the hose
1
connection. Make sure that it has clicked into
place.
Place the floor nozzle on the lower end and
2
the suction tube handle on the upper end of
the telescopic tube.
Adjust the telescopic tube to the desired
3
length, by sliding up the locking mechanism
and then pushing the telescopic tube out or
squeezing it together.
Use of the accessories provided
Floor nozzle
To vacuum hard floors, press the toggle
4
switch down.
To vacuum carpeted areas, press the toggle
5
switch again in order to retract the brushes.
Upholstery nozzle round/square
For vacuuming upholstered furniture,
6
mattresses, cushions, curtains, etc.
Crevice nozzle
For vacuuming folds, crevices and corners.
7
Hard floor brush
For vacuuming hard and wooden floor. Use
8
the hard floor brush to protect the floor
from being scratched.
16
IM_ KVC710_150429_V10_HR.indb 16

Operation

Pull out the connection cable to the desired
9
length and insert the power plug into a
receptacle.
Press the On/Off switch to turn the vacuum
10
cleaner on/off.
Switch the vacuum cleaner off after use and
11
unplug it when you have finished working.
Wind the power cable around the cable
12
storage device by pressing the automatic
cable retraction switch. While you are doing
this keep the cable taut, if possible.
Parking system for pauses in vacuuming
You can store the telescopic tube with the
13
floor nozzle on the vacuum cleaner for short
pauses in vacuuming. Insert the floor nozzle
with the parking attachments into the
parking system.

Transport and storage

To carry your vacuum cleaner grasp it by the
14
handle. To store your vacuum cleaner, the
suction tube with the floor nozzle can be
mounted on the back of the vacuum cleaner
in an upright position.
29/4/15 11:56 AM