Closing The Door - Electrolux ITE2390-2 Bedienungsanweisung Mit Montageanweisungen

38
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera‐
ture.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
The FastFreeze is switch‐
ed on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The FastFreeze function
or IntensiveCooling func‐
tion is switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
The FastFreeze function
or IntensiveCooling func‐
tion is switched on.
There is no cold air circu‐
lation in the appliance.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
Solution
Refer to "FastFreeze function".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or In‐
tensiveCooling manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freezefunction" or "Intensive‐
Cooling function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Open the door only if necessa‐
ry.
Refer to "FastFreeze function"
or "IntensiveCooling function".
Make sure that there is cold
air circulation in the appliance.