Installation; Before The Installation - Electrolux HC411520 Benutzerinformation

7.1 What to do if...
Problem
There is no spark when you
try to activate the spark gen-
erator.
The flame extinguishes im-
mediately after ignition.
The flame ring is uneven.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Make sure,
you operated the hob correctly. If not the

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob,
write down the serial
number (Ser. Nr) from the
rating plate. The rating plate
is on the bottom of the hob.
AEG
HC411520GB
Typ 55 WOK 04 GA
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is released.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated
up sufficiently.
Burner crown is blocked with
food residues.
PNC 941 560 809 00
220 - 240 V
50 - 60 Hz
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.
Make sure that the injector is
not blocked and the burner
crown is clean.
servicing by a service technician or
dealer will not be free of charge, also
during the warranty period. The
instructions about the Service Centre and
conditions of guarantee are in the
guarantee booklet.
Gas type: G20 2H
2E 2E+ - 20 mbar
Butan: 329 g/h
Ser.Nr. .................
ENGLISH 29
PIN 0063CL3461
Qn (Hs): 5.0 kW