Ignition Of The Burner; Turning The Burner Off - Electrolux HC411520 Benutzerinformation

26 www.aeg.com
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple

4.2 Ignition of the burner

Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you use
open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Push the control knob down and turn
it counterclockwise to the maximum
gas supply position (
will switch on in the two burner
crowns of Dual burner. To light the
internal crown of the Dual burner
push down the control knob and turn
it clockwise to the maximum position
( ).
2. Keep the control knob pushed for
equal or less than 10 seconds. This
lets the thermocouple warm up. If
not, the gas supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner
does not light, check if the
crown and its cap are in
correct positions.
WARNING!
Do not keep the control
knob pushed for more than
15 seconds. If the burner
does not light after 15
seconds, release the control
knob, turn it into off position
and try to light the burner
again after minimum 1
minute.
). The flame

4.3 Turning the burner off

To put the flame out, turn the knob to
the off position
4.4 Using the wok stand
The wok stand lets you use a round
bottomed wok on the hob. Use the wok
stand on the Dual burner only. When you
refit the wok stand, make sure the
recesses on the frame fit securely to the
bars of the pan supports.
CAUTION!
In the absence of electricity
you can ignite the burner
without electrical device; in
this case approach the
burner with a flame, turn the
control knob counter-
clockwise to maximum gas
supply position and push it
down. Keep the control
knob pushed for equal or
less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally
goes out, turn the control
knob to the off position and
try to light the burner again
after minimum 1 minute.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
.
WARNING!
Always turn the flame down
or switch it off before you
remove the pans from the
burner.