Interface Cable - Sony LZ60-B1 Bedienungsanleitung

3-2. Interface cable

Use a shielded cable with a thickness of ø10 mm or less for the interface cable.
Also, leave the connected device side of the shielded cable open; do not connect it to earth
(GND).
(The shielded cable should be procured separately.)
Be sure to secure the interface cable or take other measures to prevent accidental
disconnection.
Assembling the supplied plug
1 Fold back the braided wire of the portion to be inserted into the cable plug.
2 Pass the cable through the back shell and solder it to the plug.
3 Insert the plug into the back shell, then fit the front and back shells together so that the
4 Tighten the cable clamping screw to secure the cable.
Note
2
hooks on the front shell are caught in the holes on the sides of the back shell.
Cross section of the cable
Outer cover
Knitted shield
Cable clamp
4
2
3
4
1
3
Cable
Fold back the braided wire and
secure with the metal clips.
Plug
Front shell
Back shell
11