Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
File forward only until all the worn part of the tooth has been eliminated.
5.
count the file movements made on the first tooth and do the same on all the others, both right
and left ,
6.
After some sharpening the delimiting device on the chain will exceed the height of the cutting
teeth, file the exceeding part by means of a flat file to round off the depth delimiting device.
7.
Ensure that the chain is replaced before stretching to exceed the maximum adjustment of the
chain saw bar.
8.
'Deep' Filing should be performed with an electric file, we advise to use a service center to
perform this operation.
9.
Ensure that the chain slides smoothly over the bar when pulled with hands, periodically
sharpen chain and check the chain tension.
10. Bars with sprockets need frequent greasing which can be performed as follows :
-
Fill a syringe or similar device with grease for bearings.
-
Each time the saw is used grease through the hole provided near the bar tip until the
grease penetrated onto the tip.
-
After 3 times of sharpening the chain your self have it professionally sharpened, this will
ensure that all the teeth are even.
To avoid damage to the motor, do not keep the chain saw running if the chain is lodged in the wood.
Empty the fuel / oil
1. Place the machine on even and stable surface. Warm up the engine for several minutes and
then stop it.
2. Loosen the fuel / oil tank cover and remove it.
3. Drain fuel / oil into a container thoroughly.
4. Press the intake pump several times until fuel begins to empty the bulb.
5. Drain fuel / oil again.
6. Reinstall the fuel / oil tank cover.
REPAIRS
Only an authorized service centre should repair the machine.
Problem
Check
Condition
The fuel does
Fuel at the
not arrive at the
carburetor
carburetor
The fuel does not
arrive at the cylinder
Fuel at the
cylinder
There is fuel in the
exhaust
The engine
stalls, is
difficult
Sparks at the
to start or
spark plug
There is no spark
does not
electrodes
start
Sparks at the
There is no spark
spark plug
158 159
GB
Cause
Solution
Fuel filter blocked
Clean or replace
Fuel supply blocked
Clean or replace
Ask your distributor
Carburetor
for advice
Ask your distributor
Carburetor
for advice
Open the throttle
valve
Clean or replace the
The fuel mixture is
air filter
too rich
Adjust the carburetor
Ask your distributor
for advice
Switch in off
Set the switch to the
position
ON position (Run)
Electrical problem
Ask your distributor
for advice
Locked switch
Bad spacing of the
Adjust the gap to 0,6-
electrodes
0,7 mm
Electrodes
Clean or replace
contaminated
Electrodes
contaminated with
Clean or replace
fuel
Replace the spark
Defective spark plug
plug
Werbung
Inhaltsverzeichnis
