Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Press the primer (4) several times until fuel begins to fill the bulb.
2.
Turn the ignition switch (27) to the" ON "position.
3.
To start a cold engine, Pull out the choke knob (5) to the start position.
4.
During start the engine, the throttle trigger need not locked in idling position. Don't touch it
during starting.
5.
Slowly pull the starter handle until you feel it engage and then pull it quickly. Return the
starter handle gently and slowly to the original position by hand.
Note: when the engine is started for the very first time. It will require a number of attempts to
start until the fuel has travelled from the tank to the motor.
6.
Push the choke knob to the run positon as the engine started.
7.
After starting the engine, let the engine run for 2 to 3 minutes so that it warms up before
subjecting it to any load.
Under the following conditions the machine must be stop:
1.
When the motor rotary speed changes
2.
When sparks occur
3.
When saw chain are damaged
4.
In case of misfire
5.
In case of high vibration
6.
When flames or smoke appear
7.
In rain or stormy weather
Chain brake
The chain brake is a device which stops the chain instantaneously if the chain saw recoils due to
kickback.
Normally, the brake is activated automatically by inertial force. It can also be activated manually by
pushing the brake lever (Front handle guard) down toward the front.
To release brake, pull up the front handle guard toward the front handle till "click" sound is heard.
WARNING!
When the brake operates, release the throttle lever to slow down the engine speed. Continuous
operation with the brake engaged will generate heat from the clutch and may cause trouble.
Be sure to check brake operation on the daily inspection.
How to confirm:
1) Turn off the engine.
2) Holding the chain saw horizontally, remove your hand from the front handle, and let the tip of the
guide bar hit a stump or a piece of wood, and check the brake is operating. Operating level varies
by bar size.
In case the brake is not effective, ask our dealer inspection and repairing.
Sawing
During cutting, please don't keep the running speed just above clutch engagement speed. Any
prolonged use at low speed is likely to cause premature wear of the clutch.
On the other hand, the user should not keep the engine speed in max speed after cutting. Any
prolonged use at the highest speed is likely to reduce lifetime of engine.
Always take care to maintain a well balanced and secure position.
CAUTION!
In an emergency, stop the engine by moving the engine switch to the stop position.
If the saw chain strikes stone or other debris, stop the engine and check whether something has been
damaged and the saw chain is still secure.
WARNING!
Before proceeding to your job, read "For Safe Operation" section It is recommended to first practice
sawing easy logs. This also helps you get accustomed to your unit.
Always follow the safety regulations. The chain saw must only be used for cutting wood. It is
forbidden to cut other types of material. Vibrations and kickback vary with different materials and
the requirements of the safety regulations would not be respected. Do not use the chain saw as a
lever for lifting, moving or splitting objects. Do not lock it over fixed stands.
It is not necessary to force the saw into the cut. Apply only light pressure while running the engine
at full throttle.
Racing the engine with the chain seized in a cutaway can damage the clutch system. When the saw
chain is caught in the cut, do not attempt to pull it out by force, but use a wedge or a lever to open
the cut.
When cutting trees and thick branches, the teeth of the spiked bumper can be tied to the wood,
prevent slippery, and easy cutting under the focal point.
146 147
GB
Werbung
Inhaltsverzeichnis
