Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
catalytic converters.
Shake the container well to obtain a correct mixture before filling the tank.
Use at least 90 octane fuel. We recommend unleaded petrol as it leaves fewer residues inside
the motor and on the ignition plug, and prolongs the life cycle of the exhaust system. Never
use old or dirty petrol or oil/petrol mixtures. Avoid contamination with dirt or water in the tank.
Occasionally ignition knocking or clanging can be heard with high loads. This is normal and no
cause for alarm. If ignition knocking or clanging occurs during normal loads and with constant
motor speed you should change the petrol quality. If this does not solve the problem contact an
authorized specialist dealer.
When working at continuous high revs a higher octane rating is recommended.
Chain Oil
Use special chain saw oil all year round.
Only oil the saw chain in well-lit areas. Avoid spillage. Never oil the machine during operation. Let
the engine cool down for about two minutes before refilling oil.
Oil must not be carried out near naked flames, control lamps or spark producing electrical
equipment such as electric tools, welders or sanders.
1.
Make sure the machine is turned off, by turn the ignition switch to the "off" position.
2.
Check the oil by a visual check , remove the chain oil tank cap(28) and reviewing the oil level.
3.
Full oil into oil tank, because of oil expands, please fill the tank to the neck of tank only.
4.
Turn the chain oil tank cap(28) clockwise to assembly it in position.
5.
Check the chain lubrication before each use.
6.
Make sure the guide bar (13) and the saw chain (14) are in place when you check the oil
delivery.
7.
Start the engine; keep it running at medium power and check if the chain oil is delivered as
shown in the figure (Fig. 15).
8.
Adjust the chain oil flow using screwdriver (33) on the adjuster screw (Fig. 16, a) of the oiler,
which is on the bottom of the product.
Fig. 15
WARNING.
a)
Do not refill oil while engine is running or hot.
b)
Make sure oil is not leaking.
Caution!
Do not use waste or regenerated oil that can cause damage to the oil pump.
Caution!
The oil tank should become nearly empty by the time fuel is used up. Be sure to refill the oil tank
every time when refueling the saw.
Check the air filter
Check the air filter to be sure it is clean and in good condition.
Loosen the air cleaner cover screw, and remove the air filter cover, then check the main air
filter. Clean or replace the air filter if necessary.
Starting the engine
WARNING!
The cutting attachement may start to move when the engine is started. Make sure the
attachment can not come into contact with any object.
Make sure that no unauthorised persons are in the working area, otherwise there is a risk of
serious personal injury.
144 145
GB
Fig. 16
Werbung
Inhaltsverzeichnis
