Electrical Connection - AEG KD92903E Gebrauchsanweisung

5
Installation instructions

Electrical Connection

Electrical installation must be performed by an electrician qualified in accordance with
the legislation in force.
Before connecting the crockery warmer to the electric mains, check that the voltage and
frequency of the mains matches that which is shown on the rating plate located in the
heating block inside.
The electric connection is made via an omnipolar switch, which is suitable for the
intensity to be tolerated and which has a minimum gap of 3mm between its contacts,
which will ensure disconnection in case of emergency or when cleaning the crockery
warmer.
If a plug is used for the electric connection, then it must be accessible after installation.
The connection should include correct earthing, in compliance with current norms.
WARNING: THE CROCKERY WARMER MUST BE EARTHED.
If the flexible supply cable fitted to the crockery warmer ever needs to be changed, it
should be replaced by an official After Sales Service, because it requires special tools.
The manufacturer and retailers do not accept responsibility for any damage that
may be caused to people, animals or property if these installation instructions are not
observed.