Side Car Helmet Connections; Important Adwice For The Sound Volume; Technical Specifications - AKE PowerCom plus Series Bedienungsanleitung

Side car helmet connections

Only applicable to order.
power-on automatic is only activated with the driver's and pillion driver's helmet
Important advice for the sound volume
The power amplifier has a overcharge switch-off for the loudspeakers. When the
volume is too loud, the amplifier exit will temporarily be shut down. In such a case
it is essential to reduce the volume, a damage of the loudspeakers might
otherwise be possible! Especially when using ear protection plugs the volume is
adjusted at a much higher level as usually.
Absolutely do not use a higher volume than necessary!
Your hearing can be damaged by a volume that is too high.
Specifications:
Helmet connections
microphone input: 200 Ohm, dynamic or electret
sensivity: -49 dB (0dB=1V/µBar)
power on automatic: via helmet plug
helmet loudspeaker overload protection switch: > 0,2 Watt on 32 Ohm
permissible o utput impedance, each AF-amplifier output
maximum output power
supply for AKE Bluetooth Helmet Connector, etc. 5 V, 50 mA
control pin for Bluetooth Helmet Connector low-duplex / high-stereo
Audio and navigation connections (optional)
signal input stereo: R charge > 1 KOhm
sensivity headphone connection: 0 dB
sensivity loudspeaker connection: -20 dB
frequency range: 20 Hz - 20 000 Hz
automatic driving noise dependent volume control
common mode rejection
supply for Bluetooth dongle, etc.: 9 V, < 50 mA
two-way radio, mobile phone and smartphone connections (optional)
signal input : R charge > 1 Kohm,
sensivity loudspeaker connection: -20 dB
sensivity headphone connection: 0 dB (over integrated preamplifier)
30
Please consider that, when using 3 or 4 helmets, the
Additionally, the driver's concentration
on the traffic is not ensured any more.
: 4 x 6 Watt
: > 90 dB (connecting on push-pull-amplifier)
, Pin 1-2: < 3k3
: 4 Ohm
> 1 : 6
.