Prevention Of Interferences With Electrical Equipment Of The Vehicle; Mounting Of The Helmet Connector Socket; Which Helmet Sets Are Suitable - AKE PowerCom plus Series Bedienungsanleitung

Prevention of interferences with electrical equipment of the vehicle

Motorbikes are normally not very well dejamed. The control device of the
PowerCom motorbike communication system is equipped with a filter against the
electronic interferences which overlay the power supply. The version with the
hands-free kit for two-way radio or mobile phone is additionally equipped with a
special case for screening against electromagnetic interferences. Nevertheless,
you should consider the following when mounting:
· Don't install the cables near any ignition device or ignition cable
· Use only one ground connection for all devices
· The housing should be insulated from metallic chassis parts
· Let the vehicle as well as possible dejam (spark plug, etc.).
· Don't operate 2-wa
· Only use equipment that is EMC-safe.
We assume no liability for any reduced usage caused
by interferences of the motorbike or other equipment!

Mounting of the helmet connector socket

Please install the helmet connector socket using the enclosed cable fixer. Make
sure to place it on the break protection sleeve as shown in the picture. Fixed like
this the plug connection can not tilt on accidental or
forced disruption.
The helmet connections are extensively weatherproof.
despite sealing water comes between the contacts, a feed-
back between loudspeaker and microphone line is unavoi-
dable. In this case the amplifier outputs switch down. If you
hear a screech, switch off the electronic box immediately!
To dry wet connections we recommend
to blow them out and spray our
WET.Protect E-Motorbike from time to time.

Which helmet sets are suitable?

The PowerCom system
The helmet microphones and loudspeakers used should therefore be qualified for
high volume ranges. At the same time the microphone must suppress the driving
noise, the wind noise and the impact sound noise as far as possible and has to be
able for automatic helmet detection. An ideal operation can only be achieved with
the appropriate original AKE PowerCom helmet sets
At PowerCom systems with Bluetooth interface for helmets, please use the
PowerCom-optimised version of the AKE Bluetooth helmet sets.
¹) Electro Magnetic Compatibility. Some two-way radios, etc. are very sensitive to inter-
ferences passed down e.g. by the connecting cable to the microphone input.
y radio or cell phone too close to control device
is designed for an operation with high speed driving noises.
1
If
Body-
pipe
Cable fixer
.
Cable fixer
23