Herunterladen Inhalt Inhalt Diese Seite drucken

Hands-Free Kit Of Two-Way Radio - AKE PowerCom plus Series Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

o
Two channel operation possible. Connection of stereo devices possible

Hands-free kit of two-way radio

All PowerCom versions with hands-free kit for two-way radio offer the possibility to
connect CB, LPD, PMR and other two-way radios. The connection is provided with
an optionally available adapter for two-way radio systems.
Please remove the protective cap at the PowerCom control device, marked [F].
Plug in the adapter and slide the supplied weather protection centrically over the
plug connection. Now take the cable (not close to the ignition wires) and connect
the other end with your two-way radio system.
The fit-for-motorbike hands-free kit will provide you with the following combina-
tions for your convenience:
o
Automatic volume control of the two-way radio signal depending on road
noise
o
Road noise compensated automatic voice control (fit-for-motorbike VOX)
possible when using the optional user interface with hands-free operation
or manual operation with transmission button
o
If applicable, volume lowering of the audio signal (music) and the
navigation system signal possible while using the two-way radio
o
Automatic modulation adjustment depending on driving noise or with
trimmer for optimum transmission
o
Universal modulation output will recognize whether y
equipped with a dynamical or electret microphone and adapts auto-
matically
o
ON TOUR and INNOVA comes additional with elimination of the VOX
response delay from two-way radios ²
The antenna of the two
control unit. The VOX must be disconnected, if applicable.
CTCSS and DCS should only be switched on if absolutely necessary.
Please mind the National Communication Law when using two-way radios.
For further information regarding the mounting of two-way radio, antenna, etc.,
please read the operating and installation instructions of the equipment used.
¹) activated by iVOX - activator at remote connector [ R ] of the PowerCom-System.
²) many radios need a long time, to switching from receiving to sending, thereby the
beginning of the sentence can be cut off with VOX operation.
-way radio
should not be positioned close to the PowerCom
our two-way radio i
Sub-audio-sound, like
¹
,
s
27

Werbung

Kapitel

Inhaltsverzeichnis
loading

Verwandte Produkte für AKE PowerCom plus Series

Inhaltsverzeichnis