Cameo Light Q SPOT 15W Bedienungsanleitung Seite 16

SYSTEM SETTINGS (Settings)
To select the system settings, press the MODE button repeatedly until "Menu DMX Addr" or "Menu Mode" appears on the display. Using the UP and
DOWN buttons, select the "Menu Settings" menu item and confirm with ENTER. The required sub-menu can be selected as desired by using the UP
and DOWN buttons and activated by pressing ENTER (see tables, observe the sub-menus)
Settings
Display Rev = Rotation of the display by 180°
Display = automatic display switch-off
DMXFail = Operating status with DMX signal
interruption
Dim.Curve =
Dimmer Resp. =
IR Remote =
Factory Reset =
16
Dimmer Curve
Dimmer response
enables control via IR remote control
or switch off
Reset to factory settings
Display Rev On Rotation of the display by 180° (e.g. overhead
installation)
Display Rev Off Normal display
Display On = permanently on
Display Off = automatic switch-off of the display after 1 minute
of inactivity.
Hold = last command is held
Blackout = activates Blackout
Linear = The light intensity increases linearly with the DMX
value.
Exp = Adjustment of the light intensity is finer in the
lower DMX value range and coarser in the upper
DMX value range.
Log = Adjustment of the light intensity is coarser in the
lower DMX value range and finer in the upper DMX
value range.
S-Curve = Adjustment of the light intensity is finer in the
lower and upper DMX value ranges and coarser in
the middle DMX value range
LED = The spotlight responds abruptly to changes in the
DMX value.
Halogen = The spot behaves in a manner similar to that of a
halogen lamp with gentle changes in brightness
On = enables control via IR remote control
Off = disables control via IR remote control
Reset Now? ENTER = Reset to factory setting
MODE = do not perform reset