LGB 25851 Bedienungsanleitung Seite 7

USA GB
25851
DR Mallet Steam Loco,
99 201
THE PROTOTYPE
Built 1917 for the Heeresfeldbahn
(military field railway), this huge
meter gauge Mallet locomotive
was used by the Königlich Bay-
erische Staatsbahnen
Bavarian State Railway) on their
scenic branch line from Eichstätt
to Kinding. When all German
state-owned railways were incor-
porated in the Deutsche Reichs-
bahn (DR) during the 1920s, the
loco was renumbered 99 201. It
continued to haul freight and pas-
senger trains until the Eichstätt
line was regauged to standard
gauge in 1934.
THE MODEL
This detailed replica features:
- weather-resistant construction
- opening cab doors
- four-way power control switch
- two protected gearboxes with
seven-pole Bühler motors
- twelve powered wheels
- one traction tire
- twelve power pickups
- voltage stabilization circuit
- smoke generator
- simulated fire box fire
- automatic directional lanterns
- one multi-purpose socket
- length: 510 mm (20.1 in)
- weight: 3400 g (7.5 lb)
THE PROGRAM
With this model, we recommend
the following items:
31065 DR Passenger Car
901-204
38074 DR Passenger Car
901-202
40220 DR Bed Frame Gondola
45690 DR Flatcars, Platform,
2 pieces
48110 DR Covered Gondola
For information on the complete
LGB program, see the LGB cata-
log.
Operating Modes
This model has a four-way power
control switch mounted inside the
cab (Fig. 1, 2):
Position 0: All power off
Position 1: Power to lights and
Position 2: Power to lights, smoke
Position 3: same as Position 2
(Royal
Multi-Train System
This model has a decoder inter-
face. For Multi-Train System oper-
ation, it can be equipped with two
LGB MTS Decoders (55020)
using one MTS Decoder Interface
Cable (55026).
We strongly recommend decoder
installation by an LGB service
station. For more information,
contact your authorized LGB
retailer or an LGB service station
(see Authorized Service).
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board must be set to OFF. The
DIP switches should remain in
this setting, even if the model is
used on an analog layout.
Lighting
This model features directional
lighting. The model has a "flat"
multi-purpose socket, with a
removable cover, on the rear of
the loco (Fig. 3). This socket can
be used to provide track power to
cars with lighting or sound elec-
tronics.
To remove the cover of the sock-
et, pull it straight out. If the cover
is tight, gently use a small straight
screwdriver to pry it out. (Do not
pull out the rectangular outer
housing.)
Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gener-
ator is overfilled, it will not convert
smoke generator
generator and motors
(factory pre-set)
7