Yamaha I88X Bedienungsanleitung Seite 26

Digital Input/
Output
ADAT/DIGITAL
OPTICAL IN, OUT
DIGITAL STEREO
IN, OUT
MIDI IN, OUT A/B DIN 5pin
mLAN 1/2
*1: Signal input from ADAT-compatible device: Normal Rate Fs 44.1KHz(–6%) to 48KHz(+6%)
*2: Always balanced, regardless of whether a XLR-3-31 or TRS phone is used. (1=GND, 2=HOT, 3=COLD/Tip=HOT, Ring=COLD,
Sleeve=GND)
*3: Balanced Phone (Tip=HOT, Ring=COLD, Sleeve=GND)
*4: INSERT IN & OUT feature unbalanced phone jacks. (Tip = OUTPUT, Ring=INPUT, Sleeve=GND)
*5: ALESIS proprietary multi-channel optical digital interface format
In these specifications, when dBu represents a specific voltage, 0 dBu is referenced to 0.775 Vrms.
■ Control
Input Gain
Phantom Switch
Gain Select Switch (PAD Switch)
Peak LED
Monitor Select Switch (Fs Indicator)
Monitor LED (Fs Indicator)
Monitor Volume
Master Volume
Optical Select Switch
Master Clock LED
mLAN Active LED
Power Switch
*6: Phantom power (+48 V) is not supplied when the TRS phone is used. If the [HI-Z/LINE/MIC] switch is set to HI-Z, phantom
power is not supplied to INPUT jack 1.
■ Others
Supplied Accessories
Power Consumption
Dimensions
Weight
* Specifications and descriptions in this owner's manual are for information purposes only. Yamaha
Corp. reserves the right to change or modify products or specifications at any time without prior
notice. Since specifications, equipmentr or options may not be the same in every locale, please
check with your Yamaha dealer.
26
Connector Format
*5
ADAT
OPTICAL
IEC-60958 Consumer use
(DIGITAL)
RCA PIN IEC-60958 Consumer use
MIDI
IEEE1394 6pin mLAN
Double Rate Fs 88.2KHz(–6%) to 96KHz(+6%)
Gain Knob 1, 2, 3, 4, 5/6, 7/8
Phantom (+48V) On/Off for Input1,2 channel with LED
Input Ch 1 : Mic/Line/Hi-Z, Input Ch 2 : Mic/Line
Input 1, 2 channel
Direct Monitoring Channel Selector : 1/2, 3/4, 5/6, 7/8, Digital In / Fs Indicator
(holding down a while)
Direct Monitoring Channel Selector : 1/2, 3/4, 5/6, 7/8, Digital In / Fs Indicator :
44.1, 48, 88.2, 96kHz
Direct Monitoring Volume for selected channel by monitor switch
Output Level of Master Output L/R and Phones
Digital / ADAT Normal / ADAT Double
mLAN / ADAT / Internal (fixed at 44.1kHz)
For Information of mLAN's situation
Stand by/On switch
Power Adaptor (PA-5D), Owner's Manual set, CD-ROM x 2, mLAN (IEEE1394)
cable
16W
480(W) x 372.7(D) x 44(H)
3.9kg
Recommended
output level
Supports DOUBLE
—
(up to 96 kHz).
—
The IN jack features an internal
0.5Vpp/75Ω
sampling rate converter.
—
— Compatible with S400 and S200
*6
Other details