Turning The Power To The I88X And Connected Devices On And Off - Yamaha I88X Bedienungsanleitung

Turning the Power to the i88X and
Connected Devices On and Off
Before you connect the power adapter, make
sure that the i88X [STANDBY/ON] switch is set
to STANDBY (Off).
A
Connect the plug of the power adapter
(PA-5D) to the DC IN terminal on the
rear panel of the i88X.
B
Plug in the AC cable to an appropriate
AC outlet.
Rear panel
DC IN
OUT
1 DC IN
terminal
Follow this procedure in reverse order
NOTE
to disconnect the power adapter.
WARNING
• Be sure to use the included adapter. Using an
AC adapter other than the PA-5D may cause
damage to the i88X, and may even pose a
serious electrical shock hazard.
• Connect the adapter to an AC outlet of the
specified voltage.
CAUTION
Even when the [STANDBY/ON] switch is in the
STANDBY position, a small amount of electric-
ity is still flowing to the unit. When you do not
plan to use the i88X for an extended period of
time, be sure to unplug the AC power adapter
from the AC outlet.
Sequence of turning on and off the
power to the connected devices
After you connect the i88X and external
devices (page 13), make sure that the volume
setting on the i88X and external audio equip-
ment is lowered to minimum, then turn on the
power to the devices in the following
sequence.
Install mLAN Driver (for Windows)
NOTE
while the power to the i88X remains off.
(See the separate Installation Guide.)
12
Preparation
MIDI
AC outlet
2
IN
Power adapter
PA-5D
1. Turn on the power to the external
devices, such as a sound source or effects
processor connected to the input and
output of the i88X.
2 Turn on the
power to
the i88X.
3 Turn on the power to
the external audio
equipment connected
to the output of the
i88X. (mixer → ampli-
fier)
After you turn on the power to the i88X
NOTE
again, restart the DAW.
To turn off the power to the devices,
first lower the volume of the audio
equipment, then turn off the power in
the reverse sequence.
Turning on the power to the i88X
CAUTION
To protect your speakers, before you turn the
power to the i88X on or off, lower the volume
setting on the i88X and connected audio
equipment.
A
Press the i88X [STANDBY/
ON] switch to turn on the
power to the unit.
B
Raise the volume of the amplifier to an
appropriate level.
C
Set the i88X [GAIN] con-
trols, [MONITOR VOLUME]
control, and [MASTER VOL-
UME] control to an appro-
priate level.
POWER
ON!!