1.
MODE BUTTON
2.
SET BUTTON
3.
ALM ON/OFF BUTTON
4.
UP/°C/°F BUTTON
5.
MANUAL BUTTON
Power Supply
Open the battery compartment (9) and insert three batteries, type 1,5V UM-4 or AAA-cells, (preferably alkaline)
with the correct polarity as indicated by the " + " and " – " symbols inside the compartment.
Batteries contain chemical substances, so they should be disposed of properly. Incorrect use of batteries can cause
electrolyte leakage and will corrode the compartment or cause the batteries to burst. Therefore:
-
Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
-
When inserting new batteries, do not try to mix old batteries with the new ones.
-
Remove the batteries if the set is not to be used for a long time.
Manual Time Setting
1.
Press and hold SET button (2) for 3 seconds to enter TIME SET MODE
2.
Press UP / °C / °F button (4) to chose your language
a. D= German; F= French; I= Italian; S= Spanish; E= English
b. Confirm with SET button (2)
3.
Press UP / °C / °F button (4) to chose 12 or 24 Hour format
4.
Press UP / °C / °F button (4) to set the second to zero
5.
Press UP / °C / °F button (4) to set the Hour
6.
Press UP / °C / °F button (4) to set the Minute
7.
Press UP / °C / °F button (4) to set the Year
8.
Press UP / °C / °F button (4) to set the Month
9.
Press UP / °C / °F button (4) to set the Date
→Choose Week/language→12Hr/24Hr→Second→Hour→Minute→Year→Month→Date→NormalTime Display
ENGLISH
1
2
7
8
Confirm with SET button (2)
Confirm with SET button (2)
Confirm with SET button (2)
Confirm with SET button (2)
Confirm with SET button (2)
ENG 1
4
5
9
6.
SNOOZE / LIGHT BUTTON
7.
S/C ON/OFF SWITCH
8.
PROJECTION FOCI ADJUST BUTTON
9.
BATTERY COMPARTMENT
"D" flickering on display
Confirm with SET button (2)
Confirm with SET button (2)
6
3