SOUNDMASTER FUR 8097 Gebrauchsanleitung Seite 6

Alarm Setting
1. Press MODE button (1) to enter ALM MODE
2. Press and hold SET button (2) for 3 seconds to adjust the Alarm Time
3. Press UP / °C / °F button (4) to set the Hour
4. Press UP / °C / °F button (4) to set the Minute
5. Press ALM ON/OFF button (3) to activate the alarm time
6. Alarm deactivate, press ALM ON/OFF button (3)
7. Press MODE button (1) to change to the normal operating
Alarm with snooze
1. When alarming press SNOOZE/LIGHT button (6) to stop alarm for 5 minutes
2. To STOP alarm press any button except SNOOZE/LIGHT
Display switch of temperature °C/°F
In normal operating condition, press UP / °C / °F button (6) to switch °C/°F display
Manual RCC reception
In normal operating condition, press and hold UP / °C / °F (4) or MANUAL button (5) for 3 seconds to receive RCC.
RCC Signal activated: Icon
RCC Signal deactivated: Icon
Reception Instruction of RCC signal
1. After the battery installation, the device can automatically receive RCC signal when is begins to work.
2. The device will receive automatically at AM 2:00, AM 3:00 and AM 4:00.
3. Time for RCC signal reception
a) 8 minutes is possibly needed for RCC reception when the signal is weak
b) Reception of RCC stops after trying for 4 minutes when there is no RCC signal
c) 2-3 Minutes is needed to receive RCC when the signal is strong
icon indicates that the RCC signal is received successfully and time and date updating has also been
finished.
Functional Introduction
1. Clapping Controlled Back Light: Clapping hands nearby the product, or gently knocking on the table where the
product is, or lightly touching any place on the product, will turn on the LCD back light and projection light for the
convenience of night reading; and the back light will go off automatically in 5 seconds. Switch S/C (7)
position.
2. Clapping Controlled Projection Function: When the clock receives any sound signal, the LCD backlight and the
projection light will be light on. Projection can be adjusted by Foci adjustment button (8)
Specification
DC 3 x 1,5V UM-4 / AAA (Battery not incl.)
ENGLISH
will occur
will disappaear Press and hold UP / °C / °F or MANUAL button again
Confirm with SET button (2)
Confirm with SET button (2)
icon is displayed
NO icon is display
ENG 2
Hour "0" flickering on display
flickering.
ON