Installation; Installing The Pick-Up System; Adjusting The Overhang; Adjusting The Tonearm-Height - Omnitronic DD-4220 Bedienungsanleitung

Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons! Never
remove the serial barcode from the device as this would make the guarantee void.

4. INSTALLATION

Install the turntable on a plane, stable ground.
Place the platter on the holder. Please note that the platter is fixed on the holder via an extremely powerful
magnet. Place the rubber mat on the platter.
Remove the hinges from the bottom side of the styrofoam. Install the dust-cover on the two hinges.
Remove the headshell from the cartridge holder and install your pick-up system.

Installing the pick-up system

Read the user manual of the pick-up system.
Put the stylus cover on the stylus.
Connect the Headshell's connection cables with the terminals of the pickup-system and make sure that the
occupation of the cables is correct.
The different colours mean:
Used colour: Channel and poles:
White (L+) Left, plus-pole
Blue (L-) Left, minus-pole
Red (R+) Right, plus-pole
Green (L-) Right, minus-pole
Tighten the screws on the Headshell.

Adjusting the overhang:

The overhang is the distance between the stylus and the center of the turntable.
For optimized pick-up, the overhang should be set to 20 mm.
Loosen the tightening screws on the headshell and move the system forwards or backwards until you reach
the desired position.
Make sure that you tighten the screws before you operate the device again.
Screw the system on the tonearm.

Adjusting the tonearm-height

The tonarm-height varies from system to system. In order to guarantee perfect pick-up, we recommend to
adjust the tonearm-height via the adjusting-ring.
Before adjusting the tonarm-height please unlock the adjusting-ring lock.
15