Sharp XG-P25X Service Anleitung Seite 25

Replacing the R-LCD panel
(1) Disconnect the LCD flat cable from the output PWB connector.
<Figure 1>
(2) Remove the two screws "A".
(3) Lift and detach the plate "B" together with the incident light deflection plate.
<Figure 2>
(4) Remove the four screws "C" and separate the units D and E from each other.
(5) Take the R-LCD panel out of the adjusting plate.
(6) Place and fix a new R-LCD panel in the reverse steps.
(7) Adjust the deflection plate. (See page 26).
(8) Adjust the focus and convergence. (See page 21.)
~ Readjust the convergence and focus. Note that the G LCD panel needs no convergence adjustment and has
a small adjustment range in the Z direction.
A
D
SIDE VIEW
R-LCD
B
A
Fig.1
R adjusting plate
4
R-LCD panel
mounting screws
25
C
Fig.2
XG-P25X
C
E