Error Codes - Skandika Fitness MONTREUX SF-1730 Bedienungsanleitung

BODYFAT MEASUREMENT /

ERROR CODES

Hints for the shown results:
Almost not one measurement of body fat will show the same results like before. Please keep in mind
that (similar to blood pressure measurement) the smallest movements or surrounding influences or
also your daily constitution will have a strong influence upon the results. So, it is normal if you have
different results for one person within several measurements. Therefore the shown results are always
only indications to give you hints for your body constitution and will help you to find the most effective
way of training your body. The displayed values should only be regarded as evidence of your physical
condition in order to support you finding your individual best way of exercise.
Error codes
If you see an „E" (along with a number) on your computer display, this indicates that
an error has occurred.
Display: „E-1" means, that the contact to the handpulse sensors was not sufficiently for a measure-
ment. The reason for this can be, that you have not grasped the two sensors correctly. Start a new
measurement with correctly placed hands!
Display: „E-2" means, that no information is received from the sensor. A cable or the sensor itself
could be defective.
Display: „E-4" means, the measured values are not logical or that the entered values for personal data
(like e.g. height and weight) are out of range and therefore cannot be displayed resp. processed. This
may also be the result of an incorrect measuring. Please repeat the whole measurement procedure as
described in this manual.
If no correct measurements are possible or the display does not show correct values, please contact
the customer service.
53