Engine; Bowdenzüge Nachstellen; Maintenance And Care; Disposal - AL-KO 660 Bedienungsanleitung

en
Forwards and reverse
gear

ENGINE

Oil change, air filter, spark plug
See the operating manual supplied by the engine
manufacturer.
BOWDENZÜGE NACHSTELLEN
Adjustment of the Bowden cables
Cutter bar (without a lock nut)
Wheel drive
1. loosen the lock nut
2. use the adjusting screw to readjust
Correct setting:
The cutters and the wheel drive should only start
to move after the lever has travelled half the dis-
tance.
3. Retighten the lock nuts.

MAINTENANCE AND CARE

Never lift or carry the machine when the en-
gine is running. Switch off the engine, pull out
the spark plug connector, wait for all moving
parts to come to a stop.
CAUTION!
Fire hazard!
Do not store fuelled machine in buildings
where the petrol fumes might come into
contact with naked flames or sparks!
Only drain the petrol tank outdoors.
Do not spray the machine with water! Pene-
trating water (ignition system, carburettor...)
can lead to malfunctions.
If the mower is tilted to the side, the requi-
rements vary depending on the engine
manufacturer:
BRIGGS &
STRATTON
must point upwards!
See the instructions for use from the engine
manufacturer!
Always wear protective gloves when working
on the cutting tool.
18
approx. 0.50 l
The spark plug
Let the engine cool down before storing in en-
closed rooms
Spare parts and accessories
Only use genuine spare parts and genuine
accessories.
Subject to changes in design and configura-
tion.

DISPOSAL

Do not dispose of old
equipment,batteries or accumulators
as householdwaste!
Product, packaging, and accessories
were made with recyclable materials, and
should be disposed of accordingly.
TROUBLESHOOTING
CAUTION!
Risk of injury!
Remove the spark plug connector before
any maintenance or cleaning jobs!
Problem Solution
Engine does not
start
Engine output
drops off
Inexact cut
Engine
If the engine is cold:
press the primer
Top up fuel
Move the throttle lever
to the start position
Push the spark plug
connector onto
spark plug
Check spark plug, re-
new if necessary
Clean air filter
Call customer service
workshop, Resharpen /
replace the blades
Clean air filter
Call customer service
workshop
Resharpen / re-
place the blades
Readjust the cut-
ting play
BM 660-870/875/5001R
the