Seg RR 1103 Bedienungsanleitung Seite 24

S p ec ific atio ns
Specification
Power supply
Radio Frequency Tuning Range FM,AM
CD Player
Pick Up:
D/ A Converter:
C as s ette p lay er
Tape s peed
Frequency response
Earphone terminal :
Output power
Power consumption
Operating conditions
Dimensions of main unit
Weight of main unit (kg)
Signal/ Noise ratio (audio)
This product fulfils the following EU regulations :
EN 60065: 2002 + A1: 2006 + A11: 2008
EN 55013: 2001 + A1: 2003 + A2: 2006
EN 55020: 2007
EN 61000-3-2: 2006
EN 61000-3-3: 2008
Tro ub le s h o o ter
U nit dead
No functions
No s ound
S ound wobbling o r distorted.
Interference o n radio
Popping o r crackling noise
over the s ound.
W eak reception.
AC : 230 V ~ 50 Hz
DC : Battery: 6 X UM-2.
FM: 87.5-108 MHz
3 Beam Laser Pick Up
1 Bit, 8 Times Over
DA Converter
: 4.75 C M/S ec.
: 125Hz-8KHz
3. 5mm jack, stereo, < 150mV 32ohm . ( test conditions: CD @1K,
-10DB; FM @ 22.5 K,98 MHz,60 DB )
2 x 1.0 W
12 W
Temp. 0-35 C , operation status: Horizontal
260*225*124 mm ( L*W*H)
2.088kg.
55dB typical ( CD audio)
C heck unit is plugged into
mains o utlet.
Fuse b lown.
Batteries e xhausted.
W rong s ound settings selected.
Batteries interference.
E xcessive v ibration.
E xternal inference.
W eak signal.
Aerial adjustment required o r
weak signal area.
AM: 540-1600 KHz
Sampling
Plug a ppliance into mains
supply.
C heck supply w ith a nother
appliance.
R eplace p lug fuse.
R eplace b atteries.
C heck the b and selector is o n
the c orrect setting.
Is the C D d irty o r are there
fingerprints o n it.
R eplace b atteries.
Place unit on a flat, s table
surface.
C heck the a erial.
Move receiver to a n ew
location.
Try fine tuning the receiver.
Adjust aerial or move receiver
to a d ifferent location near a
window if using a n indoor
aerial.