Klarstein 10018902 Gebrauchsanleitung Seite 9

The wind mode selecting can be circulated and the wind mode pilot lamp will be on during the fan mode
in operating.
8. COOL button
Please noted that the COOL LAMP will flashing when you press the Cool button if there is no
or lacked water in water tank.
8-1 Before operating the unit in Cool mode, make sure the escape valve for the water tank is properly
fixed. Then proceed to add clean water into the water tank. While adding the water, make sure that you
keep an eye on the water level indicator to make sure that you do not OVER or UNDER FILL the unit.
Press the button Cool after you have added the water and the unit should commence to blow cooler air.
The cool light will light on at the same time. When you press the button Cool again, it will stop working,
the cool light will also go out.
8-2 If you find that the air after Step 1) is still not cool enough, you can add additional ice block into the
water tank directly by opening the water tank cover. Be sure not to exceed the icebox capacity otherwise
damage to the unit or electric shock may occur.
8-3 If you wish to use an Ice box instead of ice block, just place it directly into the tank by opening the
water door. It will be good cooling efficiency if you place it in your refrigerator and let the ice pack freeze
for 1 to 2 hours.
8-4 You may complete pull out water tank, then replace water in the water tank or clean water tank,
8-5 Under the cooling work condition, the appliance will delay 5 minutes to stop working when you shut
off the unit or timing finished, during the extended period, the timer pilot lamp is flashed.
9. ION button
To gain fresh air in your room, just press ION button and the build-in ionizer will operate.
10. The function of above item can be carried out with your remote control by pressing the corresponding
function button. The remote control can work with a distance of within 5 meters and an angle about 20
degrees.
11. How to knock down the dust-proof bracket and honeycomb filter
1. Pull out the dust-proof bracket
2. Rotate the filter knobs outwards like up photo
3. Take up the honeycomb filter
12. To turn off the unit just press the button OFF.
13. To completely shut the unit off, turn all the controls to OFF, and remove plug from the socket-outlet.
9