Inocal MTRU-W Montageanleitung Seite 14

Operating instructions
14
Setting the switch-over times
Ex-factory (default) settings:
Day-time temperature from 6.00 to 22.00 hours
Night-time (temperature reduction) temperature from 22.00 to 6.00 hours
Night-time temperature reduction: 4 K
To set night-time:
Remove the clock cap (3).
Use a pointed tool to carefully pull the clock tab (9) for the night-time
switchover outwards (identified by the blue inner edge).
To set the day-time:
The day-time clock tabs (10) are always at the inner position (no visible blue
inner edge). To change the setting, push the appropriate tab inwards.
Note:
On a week clock model, at least two clock tabs must be pulled out.
Selecting the operating mode
Use the operating mode switch (2) to select the desired operating mode:
automatic night-time reduction
day-time temperature
reduced temperature