Factory Settings And Alarm List - Abus Security Center TV8239 Installationsanleitung

Factory settings and alarm list

Press [←] and [→] to move up and down in the menu. Press [+] and [–] to make changes in menu items. If
you keep a key pressed longer than one second, you move faster through the menu or you change the
settings faster. Press [NEXT PAGE] to exit the displayed menu.
WATCH ALARM LIST: List of all alarm recordings
Press [←] and [→] to select WATCH ALARM LIST. Press [+] or [–] to enter the list. Press [+] or [–] to scroll
one page forwards or backwards in the alarm list. Press [NEXT PAGE] to exit this menu. The alarm list
contains the following entries:
• 0 -40: Event number
• P01 – P05: Page number in alarm list
• CH: Active camera
• AT: Active mode: (MD: motion detector; VL: video signal loss)
• DATE: Date of alarm activation
• TIME: Time of alarm activation
Important: The date and time in the alarm list can be shown only in the format YYYY.MM.DD.
LOAD FACTORY VALUE: Resets factory values (default settings). If you select this function, a red dot appears
on the display in front of LOAD FACTORY VALUE.
LOAD FACTORY RESET: If you select this function, all settings are irrevocably reset to the original factory
values. In contrast to LOAD FACTORY VALUE, the alarm list is also deleted. Following a reset, a red dot
appears in front of LOAD FACTORY RESET.
BORDER LINE COLOR: Sets the colour of the border line (white, grey, black, blue, red, magenta, green,
blue-green, yellow).
BORDERLINE WIDTH: Sets the width of the border line (OFF, 4.2; 8.4).
COLOR BAR: Calibrates the monitor.
If the video format used is PAL, the following appears on the screen: PAL COLOR BAR: OFF
Otherwise, the following appears: NTSC COLOR BAR: OFF
VIDEO SYSTEM CHANGE: Changes between PAL and NTSC.
WATCH ALARM LIST
LOAD FACTORY VALUE
LOAD FACTORY RESET
BORDER LINE COLOR: WHITE
BORDER LINE WIDTH: OFF
NTSC COLOR BAR: OFF
VIDEO SYSTEM CHANGE
NOW VIDEO SYSTEM: NTSC
Fig. 7
29