Transport; Cleaning; Storing - Westfalia 87 84 82 Bedienungsanleitung

adjusted high speed (high speed needle H is turned too much
clockwise) gives over revs. This will damage the engine.
Run the engine at full speed for approx. 10 seconds. Do not run it for
more than 10 seconds! Turn the H jet 1/4 turn counter clockwise. Run
the engine again for approx. 10 seconds and you will hear an audible
difference. Repeat the process and turn the H jet 1/4 turn counter
clockwise.
Turn the H jet clockwise until the sound and setting is correct. For
optimum setting of the carburettor a revolution counter has to be used.
Do not exceed the max. speed setting.

Transport

Always carry the chain saw with the engine stopped. Activate the
kickback brake to avoid unintentional start-up. Never carry or transport
the chain saw with running saw chain.
When transporting your chain saw, make sure the appropriate guide
bar cover is in place and the guide bar is directed to the rear. Only
carry the gasoline chain saw by the handle.

Cleaning


Clean the housing of the chain saw with a lightly moistened cloth, a
brush with fine bristles or similar.

Do not wipe the housing of the machine with sharp detergents or
aggressive chemicals in order not to damage the surfaces.

Storing


Before storing the chain saw for long period of time, empty the oil
and the fuel tank and run the engine out of fuel. Store fuel and oil in
approved containers.

Pull the starter handle in order to run fuel out of the carburettor. Set
the start/stop switch to the down position.

Remove the spark plug and pour approx. 10 mm fresh and clean
two-stroke oil into the cylinder.

Place a clean cloth over the spark plug hole and pull the starter
handle several times in order to evenly distribute the oil.
Transport, Cleaning and Storing
58