Octave Knobs; Data Entry Knob; Midi Channels Group; Transposer Group - Miditech i2 Control-37 Bedienungsanleitung

change the Pitch Bend range. To bend the pitch up, please move the wheel away from
you. To bend the pitch down, please move the wheel towards you.

Octave knobs

By pressing the Octave key, you will shift the active keyboard range one octave higher, or
lower. For example, if you want to change the octave 2 octaves down, press Oktave Key
twice.

Data Entry Knob

The Data Entry knob allows you to adjust the parameters by pressing the knob.
knob to select different MIDI commands on certain keys from your keyboard.The
provides several groups of MIDI commands as follows:
37

MIDI Channels group

Pressing the Data Entry knob and then pressing the MIDI CHANNEL key, this allows you
to select the transmitting channel for your keyboard. The default Channel is 1 when the
keyboard's power is turned on. Pressing the Data Entry knob, Ten Key 2 then the Data
Entry knob changes the MIDI transmit channel from 1 to 2. You can use the Data Entry
knob too.

Transposer Group

Pressing the Data Entry knob and the TRANSPOSE Key you increase or decrease the
notes by halftones. If you want to transpose by 3 semitones: Press the Data Entry knob
and the"#" key, (in the display you see 3 for three semitones) than press Data Entry knob
to finish the change.

Reset key

Pressing the Data Entry knob and the Reset key will send out a message to return all
external MIDI instruments to their default setting as well.

Control Change data entry by Numeric keypad

The i² Control-37 allows you to use the numeric keys to specify your Control Change
DATA parameter instead of data entry knob. By pressing Data Entry knob and CC data
key & then the required number and finally the Enter key to finish. For example, if you want
to make Control Change 7 as value 123.
1) Press Data Entry knob;
Use this
i² Control-