Exodraft RSV Anleitung Seite 5

3000113 RSV DK DE NO SE UK NL FR 120515
Before itting onto the brickwork of a chimney
Step Action
1 Measure the inside diameter of the chimney and cut the
size of the hole in the mineral wool mat accordingly
Note, however, that there must always be a minimum of 20
mm of mat surface at any point around the circumference
of the hole.
If a temperature sensor is to be installed with the chimney,
cut the aluminium foil on the mineral wool mat to make
room for the sensor; this also ensures that the mat sits level
on the chimney.
NB: The side of the mineral wool mat covered in aluminium
foil is to be placed uppermost, i.e. facing the fan.
2 Fit the location brackets in the grooves on the underside
of the bottom section and fasten using the nuts and bolts
supplied.
Note that the bolts are to be inserted from beneath the
brackets.
3 Adjust the distance between the location brackets to it
the inside diameter of the chimney, and then tighten the
nuts. Note that there should be a 2-4 mm gap between
the brackets and the chimney so as to avoid transmitting
vibrations from the fan to the chimney.
A and B measurements: please refer to step 1.
The chimney fan can now be itted into place. Place the mi-
neral wool mat on top of the chimney, with the aluminium
foil side up, and place the fan on top.
UK • 5