A System Description; System Components; B Preparing Device For Operation - SAFEX FlowMarker Gebrauchsanleitung

 /
22 • GA FM 1 05.01
safeX -floWMaRKeR
®
a sYsteM DescRiption
SYSTEM
COMPONENTS

b pRepaRinG DeVice foR opeRation

GENEral
FIllING OPEraTION
For best use in all fields of application of the SAFEX
to read this instruction carefully.
The safety instructions and all sections marked with an exclamation mark are
especially important and should be given particular consideration.
The FlowMarker fog generator was especially developed for the visualization of slow
and weak airflows in the fields of science and technology.
The generation of low-impulse, thermal neutral fog helps to solve even very difficult
problems of airflow visualization.
In areas with a steady airflow, even small cavities can be filled with fog. This fog, as if
flowing like water, forms a "fog lake", on the surface of which even very weak airflows
can be recognized.
The FlowMarker basic equipment consists of:
the FlowMarker device
one insert battery (12V, 2.0Ah/20Hr, type lC-TA122PU)
an unscrewable application tube, type Ar1
one pressurized can FlowMarker Fog Fluid
4 condensation absorbing rings, each type kr1 and kr2
one plastic tube for removing condensation absorbing ring kr1
a low voltage power supply, 12V = (1A, 12VA) for charging the battery inside the
device, together with 4 international wall outlet adapters
a user manual
Before first use, check the device with regard to intactness and completeness of the
standard parts. Immediately report any damages or missing parts to the supplier
or the supplier's service office.
The FlowMarker is delivered de-aerated and with the tank approximately half full for
initial testing.
a. Place the fog fluid can upright on a solid base. remove the valve protection cap.
Hold the can with one hand.
b. Hold the FlowMarker by its handle, with the fog outlet pointing up. Fit the fill
opening at the back of the device onto the valve stem of the can. Make sure to
hold the device upright, with the tank control window being visible.
c. Press the can slightly against the device to press the fog fluid from the can into
the device.
Important: No dust or dirt particles must get into the fill opening.
FlowMArkEr, it is recommended
®-