Klarfit 10026397 Bedienungsanleitung Seite 14

5. Take the 2 bottom support bars (P6) and place into the main unit. Please make sure the
top of the bottom support bars are angled away from the main unit. Take the correct
tool and use Middle screws: M6X10 and washers to secure the bottom support bars to
the main unit. This should be done at the bottom ofthe main unit. See picture P6.
6. Take the top support bars and place on top ofthe bottom support bars. Pay attention that
the top bars fit into the main support tube. See picture P7
7. Take the tool and use small screws: 5x10 to secure the top support bars to the bottom
support bars. Please see Picture P8.
8. Use the correct tool and take the big screws:M8x40 and secure the top support bars to
the main support unit. Please see picture P9.
9. Connect the wires ofthe control panel to the wires ofthe main support tube. Please see
picture P10.
10. Place the control panel onto the main support tube and feed the wires inside the main
support. Please to picture P11.
11. Finally, using screws M6X10 at the bottom side of the control panel. Then, use tool to
secure the control panel to the main support tube. Make sure to secure the front screw
first, than screw on two sides.
14