Inhaltsverzeichnis
Werbung
All Models
Power Bandwidth
THD+N
Intermoduration Distortion
Frequency Response
Channel Separation
Residual Noise
Damping Factor
Voltage Gain
Input Sensitivity (dBu)
Maximum Input Voltage
Input Impedance
Controls
Connectors
Indicators
Load Protection
Amplifier Protection
Power Supply Protection
Cooling
Power Requirements
Dimensions (W x H x D)
Weight
Included Accessories
* These specifications apply to rated power supplies of 120V, 230V and 240V.
0 dBu=0.775 Vrms, Half Power=1/2 Output Power (3 dB below rated power)
Specifications and descriptions in this owner's manual are for information pur-
poses only.
Yamaha Corp. reserves the right to change or modify products or specifica-
tions at any time without prior notice. Since specifications, equipment or
options may not be the same in every locale, please check with your Yamaha
dealer.
14
XP7000/XP5000/XP3500/XP2500/XP1000 Owner's Manual
Half Power, THD+N= 0.5 %
20 Hz–20 kHz, Half Power
60 Hz:7 kHz, 4:1, Half Power
RL=8 Ω, Po=1 W, HPF=OFF
20 Hz-50 kHz
Half Power, RL=8 Ω, 1 kHz,
Att. max, input 600 Ω shunt
20 Hz–20 kHz, Att. min,
(DIN AUDIO)
RL=8 Ω, 1 kHz
Att. max
Att. max, Rated Power 8 Ω
Switch Position
Front Panel
Rear Panel
Input
Output
MONITOR/REMOTE
POWER/STANDBY
SIGNAL
CLIP/LIMIT
PROTECTION/TEMP
MIN
10 Hz-40 kHz
MAX
0.1 %
MAX
0.1 %
MAX
0 dB
TYP
0 dB
MIN
-1 dB
MIN
70 dB
MAX
-70 dBu
MIN
350 (XP7000, XP5000), 200 (XP3500, XP2500, XP1000)
TYP
Selectable from 32 dB or 26 dB (or +4 dBu input sensitivity) by select switch
XP7000
XP5000
+4 dBu
+4
26 dB
+13.7
+12.2
36 dB
+7.7
MIN
+22 dBu
TYP
20 kΩ (balanced), 10 kΩ (unbalanced)
POWER switch (push on/push off)
attenuator (31 position) x 2
MODE switch (STEREO/BRIDGED/PARALLEL) x 1
HPF switch (20 Hz/55 Hz/OFF 12 dB/oct) x 2
GAIN SELECT switch (32 dB/26 dB/+4 dBu) x 1
XLR-3-31 type/ch, Euroblock connector (balanced) /ch
SPEAKON/ch, 5 way binding post x 1
Dsub 15 P x 1
x 1 (Green/Orange)
x 2 (Green)
x 2 (Red)
x 1 (Red)
x 1 (Red) heatsink temp ≥ 85 °C
POWER switch on/off mute
DC-fault:
power supply shutdown/operation not restored automatically. (XP7000, XP5000)
output relay off/restored automatically. (XP3500, XP2500, XP1000)
Clip limiting : THD ≥ 0.5 %
Thermal:
Cuts the output (heatsink temp ≥ 90 °C) ; operation not restored automatically.
Ω
VI limiter (RL ≤ 1
): Limit the output.
Thermal:
Power supply shutdown (heatsink temp ≥ 100 °C) ; operation not restored auto-
matically. (XP7000, XP5000).
power supply shutdown (transfomer temp ≥ 130 °C)
; restored automatically. (XP3500, XP2500, XP1000)
Variable-speed fan: x 1(XP3500, XP2500, XP1000), x 2 (XP7000, XP5000)
Fan stop at heatsink temp < 55 °C
UC: 120 V/60 Hz
HB: 230 V/50 Hz
A: 240 V/50 Hz
480 x 88 x 456 mm
XP7000
XP5000
14 kg
14 kg
Security cover (with a hex wrench), Owner's Manual
European models
Purchaser/User Information specified in EN55103-1 and EN55103-2.
Inrush Current: XP7000/5000 32A , XP3500 65A, XP2500 55A, XP1000 15A
Conforms to Environments: E1, E2, E3 and E4
XP3500
XP2500
+4
+4
+10.7
+6.2
+4.7
XP3500
XP2500
15 kg
XP1000
+4
+4
+9.2
+5.2
+3.2
-0.8
XP1000
14 kg
12 kg
Werbung
Inhaltsverzeichnis
