Sharp MD-MT877H Bedienungsanleitung Seite 127

Recording : continued
6
Press the 06 06 button to start the MiniDisc
06 06 06
unit recording.
7
Begin playback on the stereo system, the
output will be recorded.
Notes:
When recording, it is recommended to use the AC adaptor
and also install the charged battery. Should the power fail-
ure occur, the power source would be automatically
switched to the rechargeable battery.
Changing the volume level whilst recording does not af-
fect the recording.
You cannot adjust the bass level whilst recording.
To interrupt recording
Press the 06 button.
To resume recording, press the
06
The track number will be increased by one each time the
recording is interrupted.
To stop recording
Press the • /:OFF button.
When recording stops, "TOC" appears (Table Of Con-
tents). Whilst "TOC" appears the MiniDisc recorded con-
tents have not yet been updated.
To prevent the new recording from being lost it is not
possible to remove the MiniDisc whilst "TOC" is displayed.
To update the recorded contents of the MiniDisc
Press the • /:OFF button whilst in the stop mode.
The power turns off after recorded contents have been
updated on the MiniDisc.
About the TOC
After any recording or editing function "TOC" (Table Of Con-
tents) is displayed. To finalise the recording or editing func-
tion, press the •
will flash and "TOC EDIT!" will be displayed.
During any recording or editing function the MiniDisc unit lid
is locked, the MiniDisc cannot be removed until the process
is finalised.
Warning
If the power is removed (Battery/AC adaptor) whilst "TOC" is
button again.
displayed the MiniDisc unit lid will remain locked until the
battery/main power is restored and the unit is turned on. Your
new recordings or edited changes will be lost and your
MiniDisc may become unusable.
Caution:
Whilst "TOC" or "TOC EDIT!" is displayed, follow the instruc-
tions below.
– Do not jerk or bump the unit.
– Do not unplug the AC adaptor.
– Do not remove the rechargeable battery or an alkaline bat-
tery.
– Do not subject the unit to shock.
TOC display
Otherwise, tracks may not be recorded properly.
/:OFF button. During this process "TOC"
E-16