Automatic Tape Calibrator (Atc) Standard Values; Mpx Filter On/Off - T+A CC 820 M Betriebsanleitung

CLEAR ATC
(Menu point 2):
Introduction:
Selecting this menu point resets the automatic tape
calibrator (  button) values to the recorder's  
default settings.
Operation:
Press the buttons of your remote control unit in the order
shown in the diagram above.
To reset the machine's ATC settings to the standard
(default) values press the 
the menu selection process.
The screen returns to the standard display.
  button. This terminates 
FILTER / NO FILTER
Introduction:
When recording from an external tuner distortion may
result due to inaudible frequency signals (carrier
frequencies), if this tuner does not have an MPX filter.
You can eliminate these unwanted signals by switching
on the MPX filter.
Note:
You do not need to switch on the MPX filter of the
CC 820 M when making a recording from the tuner of the
PT 820 M, since this tuner is equipped with a very high
quality MPX filter.
Operation:
To switch the MPX filter on or off press the buttons of
your remote control unit in the order shown in the
diagram above.
The screen shows the current setting:
The current setting can be altered (
37
(Menu point 3):
' FILTER FILTER FILTER FILTER '
or
' NO FILTER NO FILTER NO FILTER NO FILTER '.
 /     buttons).  