barigo 44 Bedienungsanleitung Seite 46

- The chronograph is of 1/100-second resolution for the first hour and
1-second resolution for the rest and with working range up to 24 hours,
then the chronograph stops automatically.
- For the first hour, the chronograph shows minutes, seconds and
1/100-seconds, then it shows hours, minutes and seconds.
* Leading zeros will not be shown.
- There are 100 memories for lap/split times stored in a maximum of 30 runs.
- The chronograph lets you measure elapsed time, lap/split times and two (or
more) finishes.
* When you take lap/split times, the display will be frozen to show lap time,
split time and lap number for about 6 seconds, then the display will show
the current running times automatically.
To measure elapsed time
1. Press A to start the chronograph.
2. Press B to stop the chronograph.
* You can resume the measurement operation by pressing A.
3. Hold down B until the next run number is shown on the display.
* Data of the current run is stored and chronograph is reset to all zeros.
To measure lap/split times
1. Press A to start a time measurement.
2. Press A again when you want to take the first lap/split time.
3. Press A again when you want to take the next lap/split time.
* You may take up to 100 lap/split times by pressing A.
4. Press B to stop the time measurement.
5. Hold down B until the next run number is shown on the display.
* Data of the current run is stored and chronograph is reset to all zeros.
To measure two (or more) finishes
1. Press A to start a time measurement.
2. Press A again when the first runner finishes.
19