BASETech 1539300 Bedienungsanleitung Seite 47

To separate the housing parts, carefully remove the clips to detach the front part
(with electronic parts/display). You find both clips in the middle at the left and
right of the housing. Push down the housing carefully below the clips and pull the
front part of the room thermostat until both housing parts detach from each other.
• Check whether the place where you intend to install the thermostat has wires
and cables under its surface. These can get damaged by drilling.
• Remove the terminal block on the bottom part of housing and the cover of
the screw contacts. Route the cables (from the rear) through the opening of
bottom part of housing behind it. The "UP" arrow should point to the ceiling.
• Use the device as a template and
mark the locations for the borehole
on the wall (alternatively, the thermo-
stat can be installed on a 60 mm in-
wall socket). To do this use the
mounting holes in the rear panel
suitable for your mounting position.
The holes chosen should be located
opposite each other to ensure maxi-
mum stability.
• Use a 6 mm drill and bore at least 30 mm deep at the marks.
Note that, depending on the substrate, other fastening material than
the material in the installation kit .enclosed may be required. Use
the type of installation depending on the conditions.
• Press the anchors in until they fully disappear into the wall.
47