Cleaning And Maintenance - Philips Mistral GC2030 Gebrauchsanweisung

ENGLISH
8
To heat up the iron again:
1 Pick up the iron or move it slightly.
2 The red auto-off pilot light will go out.The amber temperature
pilot light will come on, depending on the soleplate
temperature.
3 If the amber pilot light comes on after the iron has been
moved, wait for it to go out before you start ironing.
4 If the amber light does not come on after the iron has been
moved, the iron is ready for use.

Cleaning and maintenance

Calc-Clean
The Calc-Clean function removes scale and impurities.
Use the Calc-Clean function once every two weeks. If the water in
your area is very hard (i.e. when flakes come out of the soleplate
during ironing), the Calc-Clean function should be used more
frequently.
1 Set the steam control to position O.
2 Fill the water tank to the maximum level.
Do not pour vinegar or other descaling agents into the water tank..
C
3 Set the temperature dial to MAX.
4 Put the plug in the wall socket.
5 Unplug the iron when the amber pilot light has gone out.
C
6 Hold the iron over the sink and set the steam control to
position v (Calc-Clean).The steam control knob will spring up
slightly.
C
7 Pull the steam control up slightly and gently shake the iron.
Steam and boiling water will come out of the soleplate. Impurities and
B
scale (if any) will be flushed out.