Geneva AeroSphère Large Installationsanleitung Seite 9

WI-FI SETUP WITh WPS
What is needed for this setup?
Your Wi-Fi router needs to support WPS. No computer or smartphone is needed for this setup.
Instructions
1. Turn the AeroSphère speaker on.
2. Wait until the display flashes in green.
3. Press the "SETUP" button on the back of the AeroSphère speaker.
4. On the Wi-Fi router press the WPS button. Typically a light on the
button starts to flash. If nothing happens, you may have to hold the
button for a few seconds. The AeroSphère speaker and the Wi-Fi
router are now starting to connect to each other.
5. Wait until the display of the AeroSphère speaker changes to button
green. This can take up to a minute. Now you are connected to your
Wi-Fi network.
WI-FI SETUP WITh ThE AEroSPhèrE nETWork SETUP WEBPAGE
Follow the detailed description in the "Feature Guide" on aerosphere.genevalab.com
4
3
What is WPS?
WPS ( Wi-Fi protected setup ) is a simple way to connect a new device
to a Wi-Fi network. WPS is a common feature on today's Wi-Fi wireless
routers or Wi-Fi access points. When pushing the "SETUP" button on
the AeroSphère Small or Large and the "WPS" button on the Wi-Fi
access point within about a minute, the AeroSphère Small or Large will
automatically connect to the Wi-Fi network.
Troubleshooting
• Repeat the procedure.
• Upgrade the software on your Wi-Fi router.
• Try another Wi-Fi setup method.
• Check the networking troubleshooting guide on the Genevalab.com
Support page.
EnGlISh
7