Geneva AeroSphère Large Installationsanleitung Seite 13

v GETTInG STArTED WITh ThE AEroSPhèrE BASE
Time required: 5 minutes
once completed: you have connected all wires and you are ready for the Wi-Fi setup.
ovErvIEW
The AeroSphère Base adds FM, DAB+ and audio CD functionality to all
AeroSphère Base speakers in the same home network. The AeroSphère
is controlled with the remote controls of the AeroSphère speakers, or
with the AeroSphère iPhone and Android App.
No separate remote control is needed to operate the AeroSphère
Base. The AeroSphère Base has no remote control sensor. You
can control the AeroSphère Base functionality directly from the
AeroSphère speakers.
connEcTInG All WIrES
Attach the Fm / DAB+ Antenna
1. Screw the enclosed FM/DAB+ antenna into the antenna connector
on the back.
2. Screw the two rods into the end of the antenna
3. Place the end of the antenna at least one meter away from the
AeroSphère Base. The long wire allows you to place the antenna in
a location where you have the best FM/DAB+ reception. Note that
only the two rods at the end of the wire is the actual antenna.
connect the power
1. Connect the AC power adapter to an AC wall outlet. Then connect
the other end of the AC power adapter into the back of the
AeroSphère Base.
2. Move the power switch to the ON position. The AeroSphère Base is
a network device and will always stay connected to the network.
next: Wi-Fi Setup
Now you are ready to connect the AeroSphère Base to your Wi-Fi
network—go to the next chapter for more details.
Do I need to configure the AeroSphère system?
No. You do not have to do additional configuration. Once the Base and
the Speakers are connected to the Wi-Fi network, the AeroSphère Base
finds all available AeroSphère speakers automatically.
English
11