Geneva AeroSphère Large Installationsanleitung Seite 8

III WI-FI SETUP For ThE AEroSPhèrE SmAll & lArGE
Time required: 5 minutes
once completed: the AeroSphère speaker is connected to your Wi-Fi network. Now you are ready to use AirPlay, DLNA and all audio sources
from the AeroSphère Base ( FM, DAB+, audio CD ).
ovErvIEW
Playing music wirelessly with AirPlay or DLNA requires the AeroSphère speakers to first be connected to your home network via Wi-Fi ( WLAN /
wireless network ). There are three different methods you can use for the Wi-Fi setup.
WI-FI SETUP mEThoD
WAC *
WPS
AeroSphère Network Setup webpage
* Enabled by default when using the AeroSphère speaker for the first time.
WI-FI SETUP WITh WAc ( WIrElESS AccESSorY conFIGUrATIon )
What is needed for this setup?
1. An iOS device ( Phone, iPad or iPod Touch ) with iOS version 7
or higher.
2. The iOS device must already be connected to your Wi-Fi network
Instructions
1. Turn the AeroSphère speaker on: wait until you see the display flash
two times repeatedly in green. When you are using the AeroSphère
speaker for the first time, this mode is already enabled. Skip step 2
and go to step 3.
2. If the display does not flash two times repeatedly in green, you can
enable the Wi-Fi Setup with WAC manually:
Hold the "SETUP" button on the back for 10 seconds, until the
display starts flashing two times repeatedly in green.
3. Go to Settings of your iOS device and select Wi-Fi.
4. Wait until you see the entry "SET UP NEW AIRPLAY SPEAKER" on
the lower part of the display. Select it.
5. Press "Next" on the upper right.
3
4
6
WhEn To USE ThIS mEThoD
You can use your iPhone, iPad, iPod Touch. They require iOS 7 or higher.
Your Wi-Fi router has a WPS push button for easy network setup.
Advanced method go to the "Feature Guide" on aerosphere.genevalab.com
6. The iOS device will now automatically transfer its Wi-Fi settings to
the AeroSphère speaker.
7. Wait until the display of the AeroSphère speaker has successfully
connected to the Wi-Fi network: the display changes from a flashing
green to a constant green.
What is WAc?
WAC is an easy Wi-Fi setup method for iOS devices ( iPhone, iPad, iPod
Touch ). By default this Wi-Fi setup method is enabled when you use
the AeroSphère speakers for the first time. The display indicates that
WAC is active by flashing two times repeatedly in green.
Troubleshooting
• Repeat the procedure.
• Make sure your iPhone, iPad or iPod touch are using iOS version 7
or higher
• Make sure your iPhone, iPad or iPod touch is connected to a Wi-Fi
network
• Try another Wi-Fi setup method.
• Check the networking troubleshooting guide on the Genevalab.com
Support page.
5
6