Power Button - Geneva AeroSphère Large Installationsanleitung

DISPlAY
The color of the Geneva logo shows the operation status of the device.
color
off
yellow
green ( constant )
green ( flashing )
blue ( constant )
blue ( flashing )
pink
red
light blue
pink
red / light blue / pink ( flashing )
green / yellow blinking
green ( flashing 3 times )
green ( repeated short single flash )
green ( repeated short double flash )
lInE-In
The 3.5 mm analog audio input on the back of the AeroSphère speaker can be used for external audio sources. Press
There are two buttons on the remote control: the upper
button selects the analog audio input of the AeroSphère Base.
BAck PAnEl

PoWEr BUTTon

Wifi Setup button
Line-in connector
AC power input connector
10
STATUS
Device is powered off
Device is starting up
AirPlay or DLNA, connected to the Wi-Fi network
AirPlay or DLNA, waiting to connect to the Wi-Fi network
Bluetooth, connected
Bluetooth, connecting or pairing
Line-In
onlY WITh AEroSPhèrE BASE
Audio CD ( AeroSphère Base )
FM or DAB+ ( AeroSphère Base )
Line-In ( AeroSphère Base )
Waiting to connect to the AeroSphère Base
ADvAncED
Failed to connect to a Wi-Fi network
Successfully connected to Wi-Fi network
Wi-Fi setup in progress ( WPS method )
Wi-Fi setup in progress ( webpage or WAC method )
button selects the analog audio input on the AeroSphère speaker, the lower
PoWEr on / oFF
WPS setup ( push button once )
WAC setup / Network webpage setup ( hold button for 10 sec )
Analog audio input ( stereo ), 3.5 mm connector
AC power input ( 100 - 240 VAC, 50/60 Hz )
on the remote control.