Geneva AeroSphère Large Installationsanleitung Seite 6

II GETTInG STArTED WITh ThE AEroSPhèrE SmAll & lArGE
Time required: 5 minutes
once completed you can play Bluetooth on the AeroSphère speaker
PoWErInG ThE SPEAkEr UP
Turn on the AeroSphère speaker
Press the power button on the remote control
button at the back of the speaker. The Geneva logo will turn yellow.
Using Bluetooth
Press the button on the remote control, and wait until the entry
"AeroSphère" appears in the Bluetooth setup of your smart phone. For
detailed instructions, go to the next chapter "Bluetooth Setup". With
Bluetooth you can listen music wirelessly without being connected to
your Wi-Fi network.
Proper placement of the AeroSphère large
The AeroSphère Large is a high performance audio system, and
produces heat during operation. This means the metal plate at the
bottom side can get hot. Do not place the speaker on a heat sensitive
surface ( such as untreated wood, etc.). The surface must be flat,
for proper air circulation underneath the unit. The speaker must
not be placed on a bed, sofa or similar surfaces that may block the
natural ventilation.
4
connect power
Turn the AeroSphère speaker carefully on its side. Don't put the
AeroSphère Large on its head. Connect one end of the power cord to the
connector to the on the bottom of the AeroSphère speaker.
Hold the end of the AC power cord tight with your fingers, and wiggle the
connector while pushing in, until it is inserted all the way. Make sure the AC
power cord is properly attached. Finally, plug the other end in a wall outlet.
remote control
Remove the plastic slip at the end of the remote control.
now go to chapter "Wi-Fi Setup for AeroSphère Small & large"
, or press the power In order to use AirPlay, DLNA or Geneva Multiroom, you need to
connect the AeroSphère speakers to your home network.