Blaupunkt Bluebot Kurzanleitung Seite 4

Which cleaning programs can I use?
Mode 1111: Automatic cleaning. Bluebot will scan the environment and decide the ideal cleaning routing.
Mode 2222: Spot cleaning. Bluebot will clean in circles when it locates excessive dirt. You can also activate the
program by pressing the 'SPOT'-button on the remote control when Bluebot is near excessive dirt.
Mode 3333: Edge cleaning. Bluebot will clean along walls and edges.
Mode 4444: Zig zag cleaning. The robot will clean in straight lines.
Press 'MODE' on the remote control while Bluebot is switched on.
How do I program a time schedule?
You can only program Bluebot when it is switched on or charging.
Set Bluebot's clock: Press the 'Scheduling' button on Bluebot (located right above the text on the robot). Four
LEDs will light up (Charging, Spot Mode, Scheduling and the ' ' on/off button). You can now set the time,
starting with the hour of the day. Press 'Charging' to go forward and 'Spot Mode' to go back. When the hour is
set, press the ' ' on/off button. You can now set the minutes. Adjust the numbers using the same buttons.
Pressing the 'Scheduling' button will cancel the procedure.
Once the time is set you can program when Bluebot should start its cleaning routine. To do so, press and hold
the 'Scheduling' button for 3 seconds. Adjust the time, again using the 'Charging' , 'Spot' and ' ' on/off buttons.
If you want Bluebot to abandon its automatic cleaning schedule, set the scheduled time to 00:00.
What do I do when Bluebot will not be used for a period of time?
Completely charge the battery and store Bluebot in a dry place.
How does Bluebot recharge?
Bluebot will return to its charging base automatically and recharge. Should you want it to recharge
beforehand, simply press the 'HOME' button on the remote control. This will order Bluebot to return to the
charging base. Alternatively, you can plug the charging cord directly into Bluebot.
Warranty details
Visit www.blaupunkt.com and register your Bluebot. (ENG)