Flash time
Here you can adapt your telephone to the specifications of your network
provider or your PABX. You can set the flash times to the following stages:
Short (100 ms), Medium (250 ms) or Long (600 ms).
Ask your network provider which settings are required for your connection or
read the operating instructions of your telephone system.
In the "Set base" menu, choose the "Flash time" entry with "OK".
If you want to change the default value, use the ◄ or ► arrow key to
select a different flash time and confirm with "OK".
Call sharing
Changing the system PIN
Certain settings can only be changed after you have entered the PIN (per-
sonal password). The factory configuration PIN is set to "0000". With this
sub-menu you can specify any four-digit PIN yourself.
ATTENTION!
Please note that the system PIN is also needed for the reset. The system
PIN itself is not reset to the default setting. Therefore, write down your
new system PIN and save it in a safe location. If you do, however, forget
your system PIN, please call our customer service.
Full ECO
The Full ECO function completely disables the telephone's transmitting
power when in standby mode. A connection between the base station and
handset is only established for outgoing or incoming calls.
64