Setup; Filling The Tray Reservoir - EuroLite BW-100 Bedienungsanleitung

Filling the tray reservoir

Fluid handling
Always disconnect from the mains before opening the housing. Do not overfill the tray reservoir.
Overfilling will result in damage to the machine. After usage, empty the tray. If fluid gets inside the
machine, have it checked by skilled personnel before it is operated.
The fluid tray is located in the front of the machine. To help avoid accidental exposure to electrical voltage, safety
screws are fitted that require a screwdriver to remove. Once these are removed, the finger screws can be undone
by hand (see illustration).
Once the screws are removed, the lid of the housing can be carefully swung upwards, as shown below and the
fluid tray can be removed for refilling. It is essential to ensure that the housing remains open and stable during
filling and cannot close independently; you can hurt yourself by sharp edges on the housing!
Revmove the tray and fill it with bubble fluid. When the tray is 3/4 full, put it back and lower the housing. Tighten
the screws.
1
Safety screw Finger screw

SETUP

WARNING!
2
13 • EN