Bosch FCS-320-TP1 Installationsanleitung Seite 24

24 en
Installation
CAUTION!
Installation must only be performed by authorized and specialized personnel!Switch off the
unit before carrying out the following work.Do not connect or disconnect the detector module
while switched on!
FCS-320-TP1 and FCS-320-TP2 System Overview
See Figure 1, Page 4
1
2
3
4
5
6
7
8
FCS-320-TT1 and FCS-320-TT2 System Overview
See Figure 2, Page 4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Jumper Assignment
See Figure 4, Page 5
Jumper JU1: fan voltage
6.9 V
9 V
Jumper JU2: collective fault contact for detector module 1 Pin 1+2
NC contact
NO contact
Jumper JU3: collective fault contact for detector module 2 Pin 1+2
NC contact
NO contact
Jumper JU4: number of detector modules
1 detector module
2 detector modules
F.01U.130.927 | 2.0 | 2010.12
Operating LED
Alarm LED for detector module 1
Alarm LED for detector module 2 (for FCS-320-TP2 only)
Collective fault LED
Pre-punched cable entries for connection to the fire panel and power supply
(input/output)
Pipe system 1 connection
Pipe system 2 connection (required for FCS-320-TP2 only)
Connection for air return pipe
Operating LED
Collective fault LED
Info alarm LED for detector module 1
Pre-alarm LED for detector module 1
Main alarm LED for detector module 1
Smoke level display in ten levels, detector module 1
Info alarm LED for detector module 2 (for FCS-320-TT2 only)
Pre-alarm LED for detector module 2 (for FCS-320-TT2 only)
Main alarm LED for detector module 2 (for FCS-320-TT2 only)
Smoke level display in ten levels, detector module 2 (for FCS-320-TT2 only)
Pre-punched cable entries for connection to the fire panel and power supply (input/
output)
Pipe system 1 connection
Pipe system 2 connection (required for FCS-320-TT2 only)
Connection for air return pipe
FCS-320-TP1 | FCS-320-TP2 | FCS-320-TT1 | FCS-320-TT2
Pin 1+2
Bypassed
Open
Bypassed
Open
Bypassed
Open
Pin 1+2
Bypassed
Open
Bosch Sicherheitssysteme GmbH
Pin 2+3
Open
Bypassed
Pin 2+3
Open
Bypassed