Installation Location; Connecting The Appliance; Electrical Connection - NEFF K5724 Serie Gebrauchsanleitung

Installation location

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g. a
cooker, radiator, etc. If installation next to
a heat source is unavoidable, use a
suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance is switched on.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior of the appli-
ance (see chapter "Cleaning the appli-
ance").

Electrical connection

The socket must be near the appliance
and also freely accessible following
installation of the appliance.
The appliance complies with the
protection class I. Connect the appliance
to 220–240 V/50 Hz alternating current
via a correctly installed socket with
protective conductor. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non-
European countries, check whether the
stated voltage and current type match
the values of your mains supply. This
information can be found on the rating
plate. Fig. .
ã=
Warning
Never connect the appliance to
electronic energy saver plugs.
Our appliances can be used with mains
and sine-controlled inverters. Mains-con-
trolled inverters are used for photovoltaic
systems which are connected directly to
the national grid. Sine-controlled invert-
ers must be used for isolated applica-
tions (e.g. on ships or in mountain
lodges) which are not connected directly
to the national grid.
en
21