GIB Lighting LXG TIMER Benutzerhandbuch Seite 21

Notes:
- The Send icon on the upper right part of the screen will flash during sending.
- If the remote control is not operated for some time in the setting state, the remote control will exit
to the non-setting state automatically, and the previous modification will not be saved.
- If the remote control is not operated for some time in the non-setting state, the remote control will
enter the power-saving mode automatically, and the screen will be turned off.
You can press any button to return to the previous image.
3.1 ON/OFF commands:
You can long-press
press ON or OFF of the remote control to send ON or OFF commands, and the lamp icon on the screen
will show ON or OFF. The ON indicator on the panel will indicate the working state of the ballast. Refer to
Table 3.
3.2 Power adjustment:
The output power of the ballast can be adjusted by the knob in the non-setting state. You can enter "Full
Information" and "Power Adjustment" of the remote control to adjust the power. Long-press
crease/decrease power rapidly. You can also press MAX or MIN to directly set the maximum or minimum
power and send to the ballast.
3.3 Clock modification of the remote control:
You can long-press CLOCK/CHECK to adjust the Clock by
modification and exit setting; press MENU to exit setting without saving the modification. The "CLOCK"
and "12:00" will flash on the screen after replacement of batteries, indicating that the Clock should be
reset.
Notes:
- Clock/Start Time of remote control is 24-hour mode.
- Please set the Clock at correct local time to ensure the ballast ON/OFF time.
Sun Function
Entering setting: Long-press MENU
Purpose: Sun Function setting, send/copy.
Note: Press MENU in the setting state, the modification will not be
saved, and the remote control will exit the setting state
automatically.
in the non-setting state to switch to the ON/OFF state of the ballast. You can
˄ ˅
or and or and press
< >
˄ or ˅ to in-
 to confirm the
EN