Changing The Atomizer Head - Vaping - Adjusting The Air Supply - Aspire Triton 2 Bedienungsanleitung

Using the Device
23
Changing the Atomizer Head
Adjust the upper ring so that the arrow points to the drop symbol to close the tank and to avoid leakage of liquid.
Then remove the head base from the device, while the mouthpiece points to the ground. The atomizer head is
located on the base. Just unscrew and replace it. Connect the components together again. Make sure that the
clearomizer is firmly closed. For vaping, adjust the upper ring again so that the arrow points to the vaping symbol.
Please also follow the instructions on page 21.
Vaping
While holding the fire button of your e-cigarette battery, inhale the vapor slowly and continuously through the
mouthpiece of your Triton 2 clearomizer. Release the fire button while exhaling the vapor.
Adjusting the Air Supply
The airflow control is located on the head base. By adjusting the airflow ring it is adaptable to your vapor
preferences. The more the two slots are open, the lower is the drawing resistance. Pay particular attention to
a sufficient air supply during sub-ohm vaping.