Candy Grand O Vita Anleitung Seite 8

DRAIN HOSE : FITTING INSTRUCTIONS
To avoid emptying the water container after each
drying cycle, the water can be discharged directly
to a waste water drain pipe (the same drainage
system as household sinks). Water Bye-Laws
prohibit connection to a surface water drain. The
waste water drain pipe should be located adjacent
to the tumble dryer.
The kit consists of:1 hose and 1 tap.
WARNING!
tumble dryer plug from the electricity supply
before carrying out any work.
Fit he t Hose a
1. Flip the machine
slowly to the right side.
2. The waste water
pipe is situated at the
right-hand side of the
machine ( see the
picture ). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the pipe
retaining clip from the
bridge.
3. Pull the hose off the
bridge connection.
Switch off and remove the
s Follows:
4. Attach the
hose from the kit,
( using the connector
a n d p i p e
supplied , to the hose )
removed from the
bridge connection.
5. Once the machine is
in place, check the
bottom to ensure that
the new hose
kink when pushing the
t u m b l e d r y e r i n t o
position.
6. Connect the new
drain hose to the waste
Water pipe.
7. Connect to the
m a i n s e l e c t r i c i t y
supply.
Caution: If the product
is in different side, wait
at least 4 hours before
switching on so that the
oil can flow back into
t h e c o m p r e s s o r .
Failure to do this could
result in damage to the
compressor.
0 8 EN
black
c l i p s
does not